Spike-2 12V connection

PinWoofer Spike-2 12V Power Cable

PinWoofer Spike-2 12V Power Cable

Pictured is the PinWoofer Spike-2 12V Power Cable.  Routes from the power jack on the amplifier to the backbox Power Distribution Board.

image6

Locating the Backbox Power Distribution Board

The Spike-2 Power Distribution Board can be seen within the yellow rectangle located in the lower right-hand corner of the backbox.

image7

CN6 Header Detail

Shown within the yellow rectangle is header CN6.

image8

Insert Cable

Plug the 3-pin connector into this location.  Note the orientation of 12V power (red) and ground (black).

image9

Connect the 5.5mm Power Plug into the Amp

Shown in the yellow oval, plug the opposite end of the cable into the Amplifier module.